Aviation software · shop floor to flight line

AWD · Harness design

Avionics Wiring

A wire has an identity, a gauge, a length, a shield, and two ends. This is the drawing that keeps all five honest from pin to pin.

Avionics installers and shops building or revising aircraft harnesses

The problem on the floor

Harnesses get built from a mix of OEM pinouts, highlighter on a PDF, and a spreadsheet that lost the revision. The aircraft and the drawing disagree, and the disagreement shows up on the ramp.

What it will not do

The software organizes the design. Continuity, crimp quality, and airworthiness still belong to the person who signs the work.

What you can do

  • Wire list with ID, gauge, color, length, shielding, and spare
  • Connector and pin callouts on both ends, including shields and grounds
  • Harness segments you can hand to a bench without rewriting the diagram
  • Revision letters tied to the aircraft and the work order

What leaves the shop

  • Wiring diagram
  • Wire running list and bill of material
  • Connector face views
  • Shop traveler the bench can mark as wires are built

Also in the line